Monet Desauw Inc.

Products

For more information about Monet Desauw products and information regarding used Monet Desauw equipment please contact us.

Power Deck PD-SE (Side Ejection POP UP UNIT)

General Specifications Dimensions: Overall width is 69”. Rollers are 60” wide. Median Height of rollers is 36”. (Legs are adjustable 4” up and 4” down for leveling and adaptability to most component saws and Power Deck™ Lumber Feed Systems.) Frame: 3” x 6” Tubing x ¼”wall thickness. Rollers: 6” x 60” x 1/8 ”wall thickness. 1 ¼”solid shaft design with baffles. Supports: Adjustable legs w/ Lifters (Unit may be anchored to floor.) Capacity: Capacity for 20’ bunk w/average weight of 4,000- 5,000lbs. Gearmotor: Sumitomo Gearmotor w/ cycloidal reducer Drive: # 60 Single Pitch Chain Drive with #60 Idler Sprockets Bearings: 2-bolt Pillow block, VSC model w/ heavy cast housings, 1 ¼” shaft

Power Deck Lumber Feed System

General Specifications (Includes Control Pedestal for use with PD-SE/SRT) Dimensions: 16’6” wide X 20’2” long, mean height is 36” (legs are adjustable 4” up and 4” down for leveling and adaptability to most component saws) Capacity: #20,000 - #25,000 load bearing Supports: 12 adjustable legs w/ swiveling feet (feet can be anchored to floor) Diagonal Bracing. Gearmotor: Sumitomo 3hp w/ cycloidal reducer (97% overall efficiency) Controls: (Compatible with TimberMill) Control Pedestal for PD and PD-SE/SRT, AC Inverter provides soft start/stop, reversing, and speed selection. Over torque system protection. Auto feed sensor on second tube, to correspond with operator side of saw. No foot pedal. Emergency Stop: Safety Shutoff cable around entire perimeter of PD. E-STOP Located on Control Pedestal Driveshaft: 1 3/4” split into multiple sections for bearing/sprocket service accessibility Idlershafts: 1 3/4” Bearings: Two per 1 3/4” Shaft/Sprocket. 4-bolt flange, VSC model w/ heavy duty cast housings, Chain: #80 single pitch for moving material, #80 single pitch on main drive

Power Deck PD-SRT (Side Receiving Table)

General Specifications Dimensions: Overall width is 69”. Rollers are 60” wide. Median Height of rollers is 36”. (Legs are adjustable 4” up and 4” down for leveling and adaptability to Lifting Section) Systems.) Frame: 3” x 6” Tubing x ¼”wall thickness. Rollers: 6” x 60” x 3/16 ” wall thickness. 1 ¼” shaft with baffles. Supports: Adjustable legs w/ swiveling feet (Feet may be anchored to floor.) Capacity: Based upon intended Material and length of roller transfer. (Capacity is typically based on 20’ bunk average weight of 4,000- 5,000lbs. (250lbs. per lineal foot.)) Gearmotor: Sumitomo Gearmotor w/ cycloidal reducer (Motor Size: 1 ½ HP Motor ) Drive: # 60 Single Pitch Chain Drive with #60 Idler Sprockets Bearings: 2-bolt Pillow block, VSC model w/ heavy cast housings, 1 ¼” shaft